Specifications Stucco Thermo-Shield Wall Coat

Insulation

NEED THIS INFO YET

Typical Uses

Thermo-ShieldŽ Stucco is designed for interior and exterior wall surfaces as a flexible wall coating. It can be applied over drywall, wood, steel, reinforced insulation board, brick, concrete block, concrete and over existing stucco. It is designed to go on ready-to-paint surfaces that meet local standards and building codes.

Color

Many colors to choose from. Minimum order of 30 gallons per color.

Theoretical Coverage

Base Coat - 150 Sq. Ft. per gallon. As the base coat provides much of the waterproofing quality of the Thermo-ShieldŽ Stucco system, it is very important to apply this recomended minimum coverage.

Finish Coat - 20 - 28 Sq. Ft. per gallon at a 50 to 70 wet mil thickness.

Drying Time

Equipment - Finish Coat Only

Low air pressure drywall hopper unit or commercial sprayer unit designed for spraying stucco.

Airless Spray: Base Coat Only

Limitations

Do not apply Thermo-ShieldŽ Texture Coat when freezing temperatures are expected within 48 hours or when rain is predicted. Ambient temperature should be 10 Deg C or above for at least 24 hours; water-based coatings depend on evaporation to cure so avoid application in damp or cold conditions. There must be good drying time of at least two hours before dew point.

Application Procedures

Apply a coat of Thermo-ShieldŽ Texture Coat Base Primer to the entire substrate. Prepare corners and joints with recommended corner bead, mesh and Thermo-ShieldŽ Texture Finish Coat. Allow drying and then apply a coat of Finish Coat to the entire structure (see application manual for more detailed information).

Application

Thermo-ShieldŽ Texture Coat has a spray or roll-on viscosity. Commercial sprayers with texture guns can be used to apply this coating. Various textures may be achieved, from a very fine sand finish to a heavy plaster coat (see manufacturer's specifications for each individual sprayer).

Clean Up

Clean tools and equipment with warm soapy water. Rinse with clean water; flush mineral spirits through spray equipment to prevent rusting and to lubricate packing and gaskets.

Packaging

Five-gallon pails.

Approximate Shipping Weight

Storage

Store Thermo-ShieldŽ Stucco Base and Finish Coat in temperatures between 50 deg F and 90 deg F.

Shelf Life

2 years

Product Codes

Warranty

10 years EXCLUSIVE REMEDY: The sole remedy for goods not in conformance with any warranty is replacement of the product or return of the purchase price. SPM Thermo-ShieldŽ shall not be liable for any other damages, including, but not limited to labor expenses.