Thermo-Shield Interior Wall Coat Specifications

Insulation

Reflectivity 89% - Emittance 94% - Conductance 0.06 W/mK - Endothermic Effect®

Typical Uses

For regular indoors painting where durability, reduction of the noise factor and superb smoke protection are important. Thermo-Shield® Interior Wall Coat reduces condensation and helps maintain an even level of comfort in the room.

Primer

No primer is usually required but it is recommended over gypsum board. Follow instructions for proper application and film build-up.

Surface Preparation

All surfaces must be clean and free from laitance (efflorescence), dust, dirt, rust, oil and grease. Minimally, surfaces must be cleaned to remove any loose or chipping paint, or any other foreign material prior to coating.

Color

Tinting may be achieved with Thermo-ShieldŽ Interior Wall Coat by the addition of universal colorants.

Percent Non-Volatile

46.61% by VOLUME / 49.77% by weight

Theoretical Coverage

10.4 sm per gallon at 150 microns DFT with no loss to be applied in 2 coats (130 sf/gal at 6-Mills DFT)

Drying Time

Thinning

None required. Clean water in small amounts of up to 0.24 Liter (1 cup) per gallon may be added to replace evaporation losses or to adjust for spray equipment configuration. Caution: excessive thinning will cause the coating to lose adhesion and elasticity.

Equipment

Roller or airless spray application is recommended. Very small areas may be brushed. When Thermo-ShieldŽ Exterior Wall Coats are applied by brush, three (3) coats cross-brushed are required for adequate protection.

Airless Spray:

Application Methods

To assure adequate and uniform coverage, the “spray and back roll” techniques are recommended - spray all coats in the same direction, do not cross spray to avoid showing undulations and other small imperfections in the walls. Thermo-ShieldŽ Exterior Wall Coats should be applied in full wet coats.

Clean Up

Clean tools and equipment with warm soapy water. Rinse with clean water; flush mineral spirits through spray equipment to prevent rusting and to lubricate packing and gaskets.

Packaging

One and five-gallon pails. Lined 55-gallon drums.

Approximate Shipping Weight

Storage

Minimum 0 Deg C – Maximum 30 Deg C Do not freeze

Shelf Life

Minimum 2 years (keep from freezing)

SETA Flash Point

Non-Flammable (water based)

DOT Class

Not regulated

Product Codes

Warranty

15 years EXCLUSIVE REMEDY: The sole remedy for goods not in conformance with any warranty is replacement of the product or return of the purchase price. SPM Thermo-ShieldŽ shall not be liable for any other damages, including, but not limited to labor expenses.